Group challenges
One-Sheet Paper Chain Challenge
Small groups have one sheet of paper, a pair of safety scissors and 30 cm of tape to make the longest paper chain they can in 15 minutes. A low-cost group challenge about planning, measuring and teamwork.
By the Success Tutoring Teachers team · Updated · Educator review in progress · How we make our resources
Setup
- Form groups of three or four and give each group its materials.
- Write the rules on the board: One sheet. 30 cm of tape. 15 minutes. The chain must hold together when lifted by one end.
- Set the timer: 3 minutes planning, 12 minutes building.
Safety
- Use safety scissors only, and cut away from the body.
- Scissors stay on the desk when not in use; no walking with scissors.
How to run the activity
- 1Say: 'Your challenge is to make the longest paper chain possible from just one sheet of paper. Before you cut anything, you have 3 minutes to plan.'
- 2Planning (3 min): groups discuss how wide each strip will be, how many strips they can get, and how they will share jobs (cutter, joiner, tape-tearer, quality checker).
- 3Building (12 min): start the timer. Remind groups at 5 minutes and 1 minute.
- 4When time is up, hands off. Each group lifts its chain by one end: if it holds, it counts.
- 5Measure each chain with the meter ruler and record the lengths on the board.
- 6Debrief: 'What did the longest chain do differently? Did thinner strips always help? What would you change next time?'
Learning outcomes
- Plan and test a solution with limited materials.
- Measure and compare lengths accurately.
- Share roles and communicate within a team.
Variations
- Two rounds: run a second round after the debrief so groups can apply what they learned.
- Strength test: the chain must also hold a peg or eraser hanging from the end.
- Estimation: each group estimates its chain length before measuring, and the closest estimate wins a bonus.
Extension
- Calculate: if each link uses a strip 2 cm wide cut along the long side of the sheet, how many strips can you get? How does strip width affect total length?
- Groups write a 'best method' instruction card for another class.
Additional support
- Draw ruled lines on the sheet beforehand so cutting is easier.
- Allow glue sticks instead of tape for students who find tape fiddly.
Extension challenge
- Groups must record their predicted length and explain it with a calculation before building.
Teacher notes
- Successful groups usually cut thin strips along the long side and make small links; very thin strips tear easily, which makes a great discussion point.
- Every group member should have a job: rotate the scissors if one person dominates.
- Students who find fine-motor tasks difficult can take the planner, measurer or quality-checker role.
More group challenges
Newspaper Tower Challenge
Teams build the tallest free-standing tower they can from ten sheets of newspaper and one meter of masking tape in 20 minutes. A classic engineering challenge with a printable design log, structured roles and a clear debrief.
Paper Bridge Strength Challenge
Teams build a bridge from just two sheets of paper to span a 20 cm gap, then load it with coins to find the strongest design. Includes fair-testing rules, a recording sheet and discussion of why folds and shapes add strength.
Silent Line-up Challenge
Each student gets a card and the class must line up in order without talking, using only gestures. Uses number, word and fraction cards rather than personal details, so no one is singled out. An eight-minute brain break with built-in learning.